AURIX Starter Kit TC277

Summary of Features

• Infineon’s TC2X7 (e.g. TC277, TC267, TC2D7) Controller in LFBGA-292 Package
• FlexRay Transceivers
• Safety device (optional)
• High Speed CAN Transceivers
• USB to UART bridge
• Ethernet Gigabit PHY(dependant of assembled Controller)
• Serial Eeprom
• LIN Transceiver
• Crystal 20MHz (default) or External Clock
• USB miniWiggler JDS for easy debugging
• 8 Low Power Status LEDs
• 8-DIP switches for configuration
• access to all pins of controller
• 100mm x 160mm (EURO-Board)
• optional power supply via USB

 Connectors :

The TC2X4 TriBoard offers a wide variety of connectors

• Standard power connector
• Micro USB connector for ASC Interface (ASC0) and miniWiggler
• RJ45 connector for Ethernet
• 16-pin header for JTAG interface (OCDS)
• 10-pin header for DAP
• 10pin (2x5) Header for LIN Transceiver (LIN)
• 2 x 10pin (2x5) Header for CAN High Speed Transceiver (CAN0 and CAN1)
• 2 x 10pin (2x5) Header for FlexRay (ERAY-A and ERAY-B)
• four 80-pin connectors (male) + four 80-pin connectors (female) with all I/O signals
• optional ETK connector 

Components:

• Infineon’s Next generation micro controller supply TLE 7368-3E
• Three LEDs to validate power supply (5Volt / 3,3 Volt / 1,3 Volt)
• LED indicating /HDRST (ESR0) active state
• LED indicating activ miniWiggler JDS
• LED switched via DAS software
• 2x Infineon’s FlexRay Transceiver  TJA1080A (NXP)
• 2x Infineon’s High Speed CAN-Transceiver TLE6250G
• Infineon’s LIN-Transceiver TLE 7259-2GE
• Infineon’s Safety Device SAK-CIC61508 (optional)
• USB to UART bridge FT2232HL (FTDI)
• Single Port Gigabit Ethernet PHY PEF7071 (LANTIQ)
• SPI eeprom (Atmel)
• 8 general purpose LEDs
• Reset switch
• 4-pin Dip switch

Parametrics