STLINK-V3MINI STLINK-V3 compact in-circuit debugger and programmer for STM32

The STLINK-V3MINI is a stand-alone debugging and programming mini probe for STM32 microcontrollers.

The JTAG/SWD interfaces are used to communicate with any STM32 microcontroller located on an application board.
The STLINK-V3MINI also provides a Virtual COM port interface allowing the host PC to communicate with the target microcontroller through one UART.
The STLINK-V3MINI is a portable version, easy-to-use debugger//programmer including STDC14 interface with its flat cable.

KEY FEATURES

• Stand-alone probe
• Approximately 15 x 30 mm high-density integration PCB
• Delivered with 1.27 mm pitch STDC14 debug connector and STDC14 to STDC14 flat cable
• Self-powered through a USB connector (Micro-B)
• USB 2.0 high-speed compatible interface
• Direct firmware update support (DFU)

• JTAG / serial wire debugging (SWD) specific features:
  • 3 V to 3.6 V application voltage support and 5 V tolerant inputs
  • JTAG communication support
  • SWD and serial wire viewer (SWV) communication support
• Virtual COM port (VCP) specific features:
  • 3 V to 3.6 V application voltage support on the UART interface and 5 V tolerant inputs
  • VCP frequency up to 15 MHz
• Drag-and-drop Flash programming
• Two color LEDs: communication, power
• Includes STDC14 signals protection